下载手机汽配人

翻译英文-起重机历史

毕业论文要用,机器翻译的不行,我英语实在太差,哪位高手帮忙翻译一下万分感谢,人名地名公司名不用翻译,一定要通顺。多谢各位朋友了。3天之内就要交。A significant word for the decade as far as the crane industry was concerned, was railways, as cranes for this industry were still very important. On 7 September 1949, for example, the Deutsche Bundesbahn (Federal German Railway) was founded. It needed high-capacity liftingdevices that could be taken to the job site as part of a train. Four steam-driven cranes, each of which could lift 57 tonnes, were ordered from Ardelt. In 1950 followed a special type of crane with a boom designed for working below overhead wires. The cranes featured a counterweight attachment system which was connected to the lifting gean This innovative design did not prove successful, but was replaced in 1955/56 by a similar hydraulic mechanism. Also in Germany, MAN had been actively building not just harbour, dockyard and travelling cranes, but also diesel-powered slewing cranes with pneumatic steering. These had been built since 1946 (picture 204), were driven by a 70 kilowatt six cylindertruck engine and could lift 6 tonnes at 7 metres radius and weighed 48 tonnes. A small concession to safety was also introduced as the company brochure tells us: "A load moment safety device, built in to the boom mechanism and thus linked to the lifting mechanism, cuts in if the permitted load moment is exceeded". The brochure writer realised the significance of the fact that the device acted when the load was exceeded and not "... as was the case ten years ago, at the point when the superstructurehas already tipped over!" These load moment safety devices, although a small part of the overall crane, were very important in the development of cranes (picture 205).
问 提问者:网友 2017-10-02
最佳回答
就起重机工业而言,二十世纪四十年代的一个重要词汇是“铁路”,因为起重机对于铁路行业来说仍然十分重要。例如,在1949年9月7日,Deutsche Bundesbahn(联邦德国铁路公司)成立。公司需要大载重量起重设备,将火车的一部分吊到工地现场。他们从Ardelt订购了四台起重量各57吨的蒸汽驱动起重机。1950年,出现了一种特殊的带有悬臂设计的起重机,用于在高架电线下工作。这种起重机带有一个连接到起重装置上的配重附着系统。这种创新设计被证明并不成功,但它于1955/56年被一种类似的液压机制所取代。也是在德国,MAN公司一直以来不仅积极制造港用、造船厂用和自走式起重机,还制造柴油动力驱动的带有汽动转向的旋臂式起重机。这种起重机自1946年起就开始制造(图204),它由70千瓦六缸卡车引擎驱动,起重量6吨,起重半径7米,自重48吨。公司还为了安全性作了一些小妥协而推出了一种装置,其宣传册上写着:"这种载荷矩安全装置内置于悬臂机制内,从而与起重机制相连,在载荷矩超过允许值时断开"。宣传册的作者认识到设备在负载超过极限时需要有所动作的重要性,而非"... 如十年前那样,上层构造已经到了翻倒的临界点!"。尽管这种载荷矩安全装置只是整台起重机的一小部分,但在起重机的发展过程中起着非常重要的作用(图205)。
回答者:网友
产品精选
在移动端查看: 翻译英文-起重机历史
搜索问答
还没有汽配人账号?立即注册

我要提问

汽配限时折扣

本页是网友提供的关于“翻译英文-起重机历史”的解答,仅供您参考,汽配人网不保证该解答的准确性。